Emerson XWEB3000 EVO Instrukcja Instalacji Pobierz pdf (Strona 7)

1592010870 XWEB3000_5000 EVO STP GB r1.0 2014.06.16.doc XWEB3000/5000 EVO 7/20

4. INSTALLATION

For installation, the XWEB-EVO system must not be opened in any way. If the box is opened, the warranty

will lapse.

XWEB-EVO can be installed in various ways based on the type of user interface access that you wish to

provide for the final user. Below is a description of the most complete procedure, i.e. where the system's

user interface can be used entirely in local control. If the system has already been configured and you wish

to use the interface through modem or Ethernet, points 5 to 9 may be optional. The particular features of

these types of connectivity are described herein.

To set up a local installation of the system, we recommend having the following equipment available:

 a Phillips and a slot-head screwdriver;

 a PS2 or USB mouse;

 a PS2 or USB keyboard;

 a monitor with a DVI or VGA connector. We recommend

using high definition monitors

The system must be installed referring to the figure below, which

illustrates the rear XWEB-EVO panel, and following the points listed

here:

1. The product has a power plug with protective earth. Make sure that

the electrical system has a protective earth connection;

2. Attach the XWEB-EVO device in the position it will be used in. If it is

installed on a table, set the rubber feet up in the holes on the

underside of the device. For rack installation, on the other hand, use

the supplied brackets and screws.

3. Connect it to the power mains by the supplied power cord (1). Set

the power plug up so that it is easily accessible at all times. Note:

Do not turn the system on;

4. Connect the RS485, the relays and digital inputs (2)(4)(16)(14)(17),

and end and/or polarise the line, if necessary (3)(15);

5. Connect any telephone lines and/or LAN network cables (7);

6. Connect any keyboard and mouse (9)(10)(11);

7. Connect any monitors (12);

8. Connect any printers (11);

9. Connect any modem: internal modem (13) or external modems (05).

The cable must not be any longer than 10 m.

10. It is now possible to turn the system on by pressing and releasing

(18);

For operator safety and to

protect the XWEB

system, before

performing any sort of

operation, connect the

system to the electrical

network by the supplied

cable. Power cord must

be the last to be removed.

 Avoid direct passage between

operators as much as possible

(to avoid electrostatic induction

and subsequent discharges);

 If the electrical voltage supply

differs from the required rating,

this could seriously damage the

system;

 Connection errors (and

connections that differ from the

prescribed ones) can pose a

danger to operator safety and

cause faults in the system and

to the instruments that are

connected to it;

 Insert one or more easily

accessible disconnecting

devices to the exterior of the

device to separate the device

from the power mains;

 Do not use the device in

environments with flammable

gases.

 Do not modify the device in any

way.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Emerson XWEB3000 EVO Instrukcja Instalacji Strona 7

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Emerson XWEB3000 EVO