Emerson Bristol ControlWave LP Instrukcja Konfiguracji Pobierz pdf (Strona 16)

Setting Configuration Parameters

Defining IP Parameters

Click on the 'IP Parameters' tab, and specify the IP address of the host ControlWave controller in

the "IP ADDR A" field; NOT the Network Host PC (NHP).

If another ControlWave controller serves as a redundant standby unit for the host controller,

enter the redundant unit's IP address in the "IP ADDR B" field.

NOTE: For more information on what the other parameters on this page mean, please refer to

Chapter 5 of the Open BSI Utilities Manual (document# D5081).

NOTE: The “Challenge Protocol Default Username” refers to a username defined on the

‘Security’ page of the Flash Configuration utility. The same combination of the

username/password defined on that page must also be defined in the host ControlWave unit in

order for a successful sign-on, and communications between the host and the I/O rack. If no

default username, is assigned, the system will attempt to use, “SYSTEM” and “666666” as the

username/password, and failing that, the first defined username/password combination in the

system. Redundancy, PAP/CHAP protocols, and host-to-I/O rack communications all make use

of this username/password combination.

For the I/

rack, this is the IP address

of the host ControlWave controller;

the Network Host PCnot

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 32 33

Brak uwag

Emerson Bristol ControlWave LP Instrukcja Konfiguracji Strona 16