Emerson Network Router Instrukcja Użytkownika Pobierz pdf (Strona 50)

44 ProLink

II Software for Micro Motion

Transmitters

Transmitter Configuration, Characterization, and Calibration

5.2.2 Loading a configuration file to a transmitter

To load a configuration file:

1. Choose

File > Send to Xmtr from File.

2. Use the file dialog to locate the configuration file and click

Open.

3. Click

Upload Configuration.

4. When the load is complete, click

Close.

If problems occur during the load:

1. Choose

View > Preferences.

2. Select

Error Log On.

3. Try to load the configuration file again.

ProLink II will now save an error log for the load process, and will display a message telling you

where to find the log file.

5.3 Configuring a transmitter

The procedures in this section provide a general method for configuring your transmitter using

ProLink II. Depending on the transmitter you are connected to, different tabs are displayed, and

different options are displayed on each tab.

For specific configuration information for your transmitter, refer to the transmitter manual.

Transmitter manuals are shipped with the transmitter, and are also available on the Micro Motion web

site (www.micromotion.com).

To configure a transmitter, choose

ProLink > Configuration. See Figure 5-1.

Note: Before making changes to your transmitter’s configuration, be sure that you have saved the

configuration to a file as described in Section 5.2.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 95 96

Brak uwag

Emerson Network Router Instrukcja Użytkownika Strona 50