Emerson ROSEMOUNT 5300 Dokumentacja Pobierz pdf (Strona 26)

Reference Manual

00809-0600-4026, Rev BA

December 2011

Rosemount Process Radar

2-16

10. This step is not applicable for FOUNDATION fieldbus. The parameters are

entered in the AI-block instead.

Fast Key Sequence [2, 1, 6]

For HART communication, choose Primary Variable, PV.

Specify the analog output range by setting the Upper Range Value (20

mA) and the Lower Range Value (4 mA) to the desired corresponding

level values.

The Alarm Mode specifies the output state when a measurement error

occurs. Choose between the following:

High: 21.75 mA (standard) or 22.5 mA (Namur)

Low: 3.75 mA (standard) or 3.6 mA (Namur)

Freeze: the output current is set to the last valid value at the time when

the error occurs.

Click Next.

11. Continue with Steps 2 to 5 in the Guided Setup window:

Step 2: Device specific setup might advise you to make further

configurations. Fast Key Sequence [2, 1, 7, 2].

Step 3: Restart the device to make sure all configuration changes are

properly activated.

Step 4: View live values from the device to verify that the transmitter

works correctly.

Step 5: Make a complete backup of the device.

12. The Basic Configuration with the Radar Master Wizard is now finished.

Proceed with the Device Specific Setup to see which additional

configuration is needed. It will recommend to calibrate Vapor

Compensation or Probe End Projection, or to perform a Trim Near Zone

if it needs to be done. For further information, see the Rosemount 5300

Series Reference Manual (Document No. 00809-0100-4530).

For Signal Quality Metrics information and further configuration, see the

Rosemount 5300 Series Reference Manual (Document No.

00809-0100-4530).

Step 1: Run Wizard

Step 3: Restart the device

Step 4: View live values from the device

Step 5: Make a complete backup of the device

Step 2: Device specific setup

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 105 106

Brak uwag

Emerson ROSEMOUNT 5300 Dokumentacja Strona 26