Emerson E2 Instrukcja Operatora Strona 51

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 71
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 50
51
Note: There are no unique injection valve service
procedures for the 4D Intelligent Store™ com-
pressor. Use conventional 4D valve change-out
procedures.
1. Disconnect power to the compressor and module.
2. After isolating the liquid line by closing the shut-
off, relieve trapped pressure by actuating the sole-
noid.
This is very important! When heated, pres
-
sures generated by trapped refrigerant may
lead to a ruptured tube. Wear safety goggles
when using a torch. Evacuate the compressor
per accepted industry practice. Unsolder the injec-
tion tube below the side box. Keep the torch flame
out of the side box to avoid burning the wire har-
ness. A wet rag around the valve is recommended
for additional protection.
3. Unsnap the injection coil and lift it off of the valve
stem.
4. Unplug the two Deutsch harness connections that
enter the side of the rear terminal box. Depress
the two tabs (top and bottom) to release the con-
nectors.
5. Remove screws “A” and “B” (see the enclosure
diagram above, and the accompanying photo-
graphs).
5.1.5 Injection Valve Replacement (2D / 3D)
Reference Drawing of 2D / 3D Enclosure and Accessories
TEMPERATURE SENSOR
GROUND SCREW
LOW PRESSURE CUTOUT SWITCH AND CONNECTOR
White Dot in Center
Blue Wire Harness (LPCO)
HOUSING COVER NUTS
SCREWS “A”
FRONT CONTROL BOX
HARNESS ANCHOR
HIGH PRESSURE CUTOUT SWITCH AND CONNECTOR
Red Dot in Center
Red Wire Harness (HPCO)
DISCHARGE TEMPERATURE PROBE
Black/White Harness
Attach Green Wire to Ground Screw
SCREW “B”
SIDE BOX
DEMAND COOLING
SOLENOID COIL
Brown Wire Harness
(Liquid Injection)
HARNESS CONNECTORS
To Remove: Depress 2 tabs before pulling
To Install: Push in until connector “snaps”
Install Torque
25-30 ft-lb
Screw B
Deutsch Plugs
Screws A
AE8-1337 R1
Przeglądanie stron 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 70 71

Komentarze do niniejszej Instrukcji

Brak uwag