Emerson FM-3 Instrukcja Instalacji Pobierz pdf (Strona 127)

113

Parameter Descriptions

Enable Registration Window Index.#.RegistrationWindowEnable

This check box enables (if checked) the Registration Sensor valid Window. When active,

only registration marks that occur inside the registration window are seen as valid.

Window End Index.#.RegistrationWindowEnd

This parameter defines the end of the Registration Sensor Valid Window relative to start

position of this index. This is an unsigned value and is relative only to starting position of this

index. Index direction does not affect this parameter. The Registration Window start position

is greater than or equal to the Registration point and less than the Registration Window End

position. If a registration sensor is seen outside of this window (not between the WindowStart

and WindowEnd positions) then it will be ignored.

Window Start Index.#.RegistrationWindowStart

This parameter defines the start of the Registration Sensor Valid Window relative to start

position of this index. This is an unsigned value and is relative only to starting position of this

index. Index direction does not affect this parameter. The Registration Window start position

is greater than or equal to the Registration point and less than the Registration Window End

position. If a registration sensor is seen outside of this window (not between the WindowStart

and WindowEnd positions) then it will be ignored.

Registration Sensor Index.#.SensorTrigger

If registration to Sensor is selected, when this destination activates, motor position is captured

and is used as the registration point for registration type indexes.

Time Base Index.#.TimeBase

The time base selects either realtime, which allows velocities, acceleration and deceleration

to be based on real time, or synchronized, which allows for an external synchronization

signal.

Velocity Index.#.Vel

This parameter sets the target velocity of the specific index. The units for this parameter are

specified in the User Units Setup view. When an index is initiated, it will ramp up to this

velocity at the specified acceleration rate and run at speed until it decelerates to a stop

(assuming the index is not compounded).

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 229 230

Brak uwag

Emerson FM-3 Instrukcja Instalacji Strona 127