Emerson FM-3 Instrukcja Instalacji Pobierz pdf (Strona 78)

FM-3 Programming Module Reference Manual

Jog Deceleration

This is the deceleration ramp used when stopping this individual Jog. If S-Curve ramps are

used, then this is the average deceleration rate for the entire ramp. The units for the

deceleration are setup in the Setup - User Units view in PowerTools FM-3.

Jog Sources and Destinations

Sources

Jog.AnyCommandComplete

The Jog.AnyCommandComplete source will activate when either Jog0 or Jog1 completes its

deceleration ramp, and reaches zero commanded velocity. It will deactivate when any Jog is

initiated again. If the Stop destination is used during a Jog, then the

Jog.AnyCommandComplete will not activate.

Jog.#.Accelerating

This source is active while a jog is accelerating to its target velocity. Once the Jog reaches the

target velocity, the Jog.#.Accelerating source will deactivate.

Jog.#.AtVel

This source activates when the individual jog reaches its target velocity. It deactivates when

a jog deceleration ramp begins.

Jog.#.CommandInProgress

The Jog.#.CommandInProgress source is active throughout an entire jog profile. The source

activates at the beginning of a jog acceleration ramp, and deactivates at the end of a jog

deceleration ramp.

Jog.#.CommandComplete

The Jog.#.CommandComplete source will activate when the specific jog completes its

deceleration ramp. It will remain active until the specific jog is initiated again. If the Stop

destination is used during a Jog, then the Jog.#.CommandComplete will not activate.

Jog.#.Decelerating

This source is active while a jog is decelerating from its’ target velocity. Once the Jog reaches

zero velocity (or its new target velocity), the Jog.#.Decelerating source will deactivate.

Destinations

The following destination functions can be found in the Assignments view under the I/O setup

group:

Jog.PlusActivate

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 229 230

Brak uwag

Emerson FM-3 Instrukcja Instalacji Strona 78