Emerson FM-3 Instrukcja Instalacji Pobierz pdf (Strona 40)

FM-3 Programming Module Reference Manual

Target Drive Address

This is the Modbus address of the target drive to which you will download the configuration.

The default target drive address is 1.

Configuration Group

The configuration group consists of list boxes for Drive Type, Motor Type, and Line Voltage.

Drive Type List Box

Select the drive model for the system you are currently setting up.

Motor Type List Box

Select the motor you want to use. Emerson Motion Control PowerTools® FM-3 software will

only display the motor models that are compatible with the drive you selected and any user

defined motors.

Caution

Selecting the wrong motor type can cause poor performance and may even damage the

motor and/or drive.

Line Voltage List Box

Line Voltage specifies the applied power and adjusts the internal gains to compensate for it.

This parameter has two choices: 115 VAC and 230 VAC. If the Line Voltage is set to 230

VAC when the actual applied voltage is 115 VAC, the motor will be slightly less responsive

to commands and load disturbances.

Caution

The Line voltage must never be set to 115 VAC if the applied voltage is actually 230

VAC. This can cause drive instability and failure.

Drive Encoder Output Group

The drive encoder output group consists of the encoder scaling check box and encoder

scaling.

Encoder Scaling Check Box

This check box enables the Scaling parameter of the Drive Encoder Output.

Encoder Scaling

This parameter defines the encoder resolution (lines per revolution) of the drive's encoder

output. This feature allows you to change the drive encoder output resolution in increments

of 1 line per revolution up to the density of the encoder in the motor. If the Encoder Output

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 229 230

Brak uwag

Emerson FM-3 Instrukcja Instalacji Strona 40