Emerson MICRO MOTION 2700 Instrukcja Instalacji Pobierz pdf (Strona 53)

Transmitter Configuration and Use: Series 1000 and 2000 Transmitters 43

Required Configuration Optional ConfigurationUsing the TransmitterFlowmeter Startup

Chapter 6

Required Transmitter Configuration

6.1 Overview

This chapter describes the configuration procedures that are usually required when a transmitter is

installed for the first time.

The following procedures are discussed:

• Characterizing the flowmeter (see Section 6.2)

• Configuring transmitter terminals (see Section 6.3)

• Configuring measurement units (see Section 6.4)

• Configuring the mA output(s) (see Section 6.5)

• Configuring the frequency output (see Section 6.6)

• Configuring the discrete output (see Section 6.7)

• Configuring the discrete input (see Section 6.7.1)

This chapter provides basic flowcharts for each procedure. For more detailed flowcharts, see the

flowcharts for your transmitter and communication tool, provided in the appendices to this manual.

Default values and ranges for the parameters described in this chapter are provided in Appendix A.

For optional transmitter configuration parameters and procedures, see Chapter 8.

Note: All ProLink II procedures provided in this chapter assume that your computer is already

connected to the transmitter and you have established communication. All ProLink II procedures also

assume that you are complying with all applicable safety requirements. See Chapter 3 for more

information.

Note: If you are using AMS, the AMS interface will be similar to the ProLink II interface described in

this chapter.

Note: All Communicator procedures provided in this chapter assume that you are starting from the

“Online” menu. See Chapter 4 for more information.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 263 264

Brak uwag

Emerson MICRO MOTION 2700 Instrukcja Instalacji Strona 53